Connect a Column Identification Tag to the Tag Reader

Tools required

Qty.		p/n	Description
2		8710-0510	Open-end wrench 1/4-5/16 inch

Parts required

Qty.		p/n	Description
1		5067-5917	InfinityLab Column Identification Tag
1			Column (up to 30 cm length)

Prerequisites

If the column is without a preinstalled identification tag, fit a new tag onto it by slipping the lanyard loop over one end of the column and pulling the cord tight through the plastic holder.

NOTE
Once the lanyard is fixed, the tag can no longer be removed from the column.
Install the column in the ICC (see Install a Column in the ICC).
Route the cord to the left and plug the column identification tag into the corresponding socket of the tag reader.
Configure the connected column with identification tag in the CDS, see Column Assignment and Using Column Identification Tags.