Specifications

Weight

14.5 kg (32 lbs)

Dimensions (height × width × depth)

180 x 396 x 436 mm (7.1 x 15.6 x 17.2 inches)

Line voltage

100–240 V~, ±10%

Wide-ranging capability

Line frequency

50 or 60 Hz, ±5%

Power consumption

80 VA, 65 W

Ambient operating temperature

4–55 °C (39–131 °F)

Ambient non-operating temperature

-40–70 °C (-40–158 °F)

Humidity

< 95% r.h. at 40 °C (104 °F)

Non-condensing

Operating altitude

Up to 3000 m (9842 ft)

Non-operating altitude

Up to 4600 m (15092 ft)

For storing the module

Safety standards: IEC, EN, CSA, UL

Overvoltage category II, Pollution degree 2

For indoor use only

ISM Classification

ISM Group 1 Class B

According to CISPR 11

Hydraulic system

Dual piston in series pump with proprietary servo-controlled variable stroke drive, floating pistons and active inlet valve, integrated 4-channel degassing unit

Designed for use with Agilent InfinityLab Assist

Intuitive User Interface, Automated Workflows, Predictive Maintenance & Assisted Troubleshooting

Flow range

Settable: 0.001 – 10 mL/min

Recommended: 0.2 – 10.0 mL/min

Set points in 0.001 mL/min increments

Flow precision

≤ 0.07 % RSD, or ≤0.02 min SD, whichever is greater

Based on retention time at constant temperature

Flow accuracy

± 1 % or 10 µL/min, whichever is greater

Pumping degassed H₂O at 10 MPa (100 bar, 1450 psi)

Pressure operating range

Up to 60 MPa (600 bar, 8700 psi) up to 5 mL/min

Up to 20 MPa (200 bar, 2950 psi) up to 10 mL/min

Pressure pulsation

< 2 % amplitude (typically < 1.3 %), or < 0.3 MPa (3 bar, 44 psi), whichever is greater

At 1 mL/min isopropanol, at all pressures > 1 MPa (10 bar, 145 psi)

Compressibility compensation

User-selectable, based on mobile phase compressibility

Recommended pH range

1.0 – 13, short term 14

Gradient formation

Low pressure quaternary mixing/gradient capability using proprietary high-speed proportioning valve

Delay volume

600 – 900 µL, dependent on back pressure

Measured with water at 1 mL/min (water/water with tracer)

Settable composition range

0 – 100 % in 0.1 % increments

Composition precision

< 0.2 % RSD or < 0.04 min SD, whichever is greater

At 1 mL/min; based on retention time at constant temperature

Instrument Control

LC & CE Drivers A.02.14 or above

Lab Advisor software B.02.08 or above

InfinityLab Assist (G7180A) with firmware D.07.40 or above

For details about supported software versions refer to the compatibility matrix of the LC & CE Drivers version in use

Local Control

Agilent Instant Pilot (G4208A) B.02.20 or above

Communication

Controller-area network (CAN), USB Extended Remote Interface: ready, start, stop and shut-down signals

Materials in flowpath

Titanium, Gold, Platinum-Iridium, Sapphire, PEEK, PTFE, Ruby, Ceramic, FEP, PFA

Active seal wash

Included