Prepare a Sampler With Thermostat for Transportation

When

The module needs to be transported or relocated.

WARNING

Heavy weight

The module is heavy.

Carry the module at least with 2 people.
Avoid back strain or injury by following all precautions for lifting heavy objects.
Ensure that the load is as close to your body as possible.
Ensure that you can cope with the weight of your load.

CAUTION

Condensate inside the module

Damage to the electronics of the module

After installation of the Sample Thermostat, wait at least 30 min before switching on the module.
Make sure there is no condensate inside the module.

CAUTION

Unsecured transportation

Mechanical damage

Secure the sampler handler assembly before transporting the sampler.

NOTE

Moving the sampler with the Sample Thermostat installed is possible for short distances (for example, from one workbench to another). For longer transportation, remove the thermostat from the sampler and handle the units separately.

Remove condensate.
1. Place a suitable container underneath the outlet pipe.
1. Remove the drainage tube.
1. Gently tap the sides of the sampler several times to facilitate the drainage of the condensate from the system.
NOTE
Do not tilt the module to avoid damage to the internal parts.
Remove all sample containers from the sample hotel.
Move the robot arm to the park position using Instant Pilot or Lab Advisor, see Arm Position.
Turn off the sampler.
Install all parts of the Transport Protection, see Install the Transport Protection Foam.
Remove the Sample Thermostat from the sampler if needed, see Replace the Sample Thermostat.

21-Jun-2025