G5668A、G7137A、G7167A、G7167B Multisampler 安装样品恒温器

注意

Visit https://www.agilent.com/ for a video tutorial on installing the Agilent InfinityLab Sample Thermostat. Find the video by the following options:

Enter the link https://www.agilent.com/search/?Ntt=install-infinitylab-sample-thermostat.

Alternatively, the video is available on the landing page of any compatible sampler under the section Videos.

警告

可燃制冷剂

样品恒温器和实验室内可形成可燃气体和空气的混合气体。

• 确保设备远离明火及火源。
• 确保具有 4 m³ 的可用空间（样品恒温器内每 8 g R600a 制冷剂需要 1 m³ 空间）。
• 确保足够的通风：通常每 1 m² 实验室面积需要 25 m³/h 的空气对流。
• 确保外壳上的所有通风口畅通。不要堵住样品恒温器四周的开口。

警告

使用的可燃制冷剂

• 搬运、安装和操作样品恒温器时，请务必小心，避免损坏制冷剂管线或样品恒温器的任何部件。

警告

如果出现损坏

• 确保设备远离明火及火源。
• 让室内通风几分钟。
• 请不要再使用样品恒温器。

小心

冷凝管的布线

冷凝管的正确布线对于正确排放冷凝水至关重要。

• 不要将进样器直接放在工作台上。

注意

如果样品恒温器的电源断开，请至少等待五分钟，然后再重新接通电源并打开压缩机。

注意

Even under average humidity conditions, a significant amount of condensed water gathers every day. A suitable container must be provided and emptied regularly in order to avoid overflow.

注意

For best cooling performance of the thermostat, the 2H drawer must be installed in the lowest position. Use the dummy drawers (G4267-60024) if no full hotel configuration is needed.

注意

Depending on the ambient conditions in the lab, the amount of condensate can vary from 200 mL to 2 L per day. Do not fill waste containers for the condensate to the top. Regularly empty the waste container.

注意

The setup with the condensate collector funnel is suitable for bench installations only. For installations on an InfinityLab Laboratory Instrument Bench, use the alternative installation described in Infinity II 冷却装置/恒温器冷凝排水管线套件的安装技术说明 (G7167-CoolerCondensateDrainage-TechPu-en-SD-29000254.pdf, SD-29000254) . Enter the link https://www.agilent.com/search/?Ntt=Installation-of-the-Infinity-II-Cooler/Thermostat-Condensate-Drainage-Tubing-Kit-Technical-Note to locate the TechNote on https://www.agilent.com/.