准备运输带恒温器的进样器

适用于

The module needs to be transported or relocated.

警告

很重

模块很重。

至少需要 2 个人才能搬动模块。
在搬运重物时应遵循所有预防措施，以避免背部扭伤或受伤。
确保负荷尽可能靠近您的身体。
确保您能承受处理的负荷。

小心

Condensate inside

Damage to the electronics

Unplug the power cords.
Drain off all condensate before dismounting the sample thermostat.
Make sure that there is no condensate left.

小心

Unsecured transportation

Mechanical damage

Secure the transport assembly before transporting the sampler.

注意

Moving the sampler with the Sample Thermostat installed is possible for short distances (for example, from one workbench to another). For longer transportation, remove the thermostat from the sampler and handle the units separately.

Turn off the Sample Thermostat.
Remove condensate.
1. Place a suitable container underneath the outlet pipe.
1. Remove the drainage tube.
1. Gently tap the sides of the sampler several times to facilitate the drainage of the condensate from the system.
注意
Do not tilt the module to avoid damage to the internal parts.
Remove all vials from the vial drawers.
Move the transport assembly to the park position using Instant Pilot or Lab Advisor, see Park Arm.
Turn off the sampler.
Install the Transport Protection Foam, see Install the Transport Protection Foam .
Remove the Sample Thermostat from the sampler if needed, see 更换样品恒温器.

21-6月-2025