Connect a Column Identification Tag to the Tag Reader

Ferramentas necessárias

Quant.		p/n	Descrição
2		8710-0510	Chave de boca 1/4-5/16 de polegada

Peças necessárias

Quant.		p/n	Descrição
1		5067-5917	Etiqueta de ID para coluna InfinityLab
1			Coluna (até 30 cm de comprimento)

Pré-requisitos

Install the Column ID Tag Reader, see Instalar o kit de atualização de ID da coluna.
Remove the column if installed, see Remover uma coluna do ICC.

If the column is without a preinstalled identification tag, fit a new tag onto it by slipping the lanyard loop over one end of the column and pulling the cord tight through the plastic holder.

NOTA
Once the lanyard is fixed, the tag can no longer be removed from the column.
Install the column in the ICC (see Instalar uma coluna no ICC).
Route the cord to the left and plug the column identification tag into the corresponding socket of the tag reader.
Configure the connected column with identification tag in the CDS, see Column Assignment and Using Column Identification Tags.

21-jun-2025