Error ID: 2016
The pressure signal is missing.
The pressure signal must be within a specific voltage range. If the pressure signal is missing, the processor detects a voltage of approximately -120 mV across the damper connector.
The pressure signal must be within a specific voltage range. If the pressure signal is missing, the processor detects a voltage of approximately -120 mV across the pressure sensor.
Probable cause | Suggested actions | |
|---|---|---|
1 | Damper disconnected. | Please contact your Agilent service representative. |
2 | Pressure sensor disconnected. | Please contact your Agilent service representative. |
3 | Defective damper. | Please contact your Agilent service representative. |
4 | Defective pressure sensor. | Please contact your Agilent service representative. |
base-id: 3820915339
id: 9007203075656331