Error ID: 6703
This message may show up during a wavelength calibration.
If the expected deviation is larger than the specified wavelength accuracy, the message Wavelength Calibration Failed is displayed and the instrument stays in a Not Ready condition.
Probable cause | Suggested actions | |
|---|---|---|
1 | Flash lamp not ignited or position not correct. | Please contact your Agilent service representative. |
2 | Cell position not correct. | Check the cell position. |
3 | Solvent in the cell not clean or air bubble in the cell. | Flush the flow cell. |
4 | Monochromator assembly position not correct (after replacement). | Please contact your Agilent service representative. |
base-id: 3586659851
id: 9007202841400843