Correcting Leaks

When

If a leakage has occurred in the flow cell area or at the heat exchanger or at the capillary connections

Tools required

Qty.	p/n	Description
1		Tissue
1		Wrench, 1/4 inch for capillary connections
1	5043-0915	Fitting mounting tool

Qty.

p/n

Description

Tissue

Wrench, 1/4 inch

for capillary connections

5043-0915

Fitting mounting tool

NOTE

Use tissue to dry the leak sensor area and the leak pan.

NOTE
To check for leaks, establish a flow and observe the flow cell (outside of the cell compartment) and all capillary connections.
Perform a Wavelength Verification and Calibration or a Holmium Oxide Test to check the correct positioning of the flow cell.