Replace the Deuterium Lamp
When
|
Tools required
Qty. | p/n | Description | |
|---|---|---|---|
1 | 
|
| Screwdriver, Pozidriv #1 PT3 |
Parts required
Qty. | p/n | Description | |
|---|---|---|---|
1 | | G1314-60101 | Deuterium lamp (with RFID tag) |
Prerequisites
|
WARNING
Injury by touching hot lamp
If the detector has been in use, the lamp may be hot.
- If so, wait for lamp to cool down.
WARNING
Injury by sharp metal edges
- Be careful when touching the RFI sheet metal at the rear of the fan. There are sharp edges.
CAUTION
Electronic boards and components are sensitive to electrostatic discharge (ESD).
- To prevent accidental electrostatic discharge when coming into contact with components inside the instrument, touch one of the metal housing panels at the front of the instrument.
-
-
-
-
-
-
RFID tag on top. Do not touch the glass bulb with your fingers. It may reduce the light output.
-
-
-
-
Reset the lamp counter as described in the User Interface documentation (required for non-RFID tag lamps only).
-
Turn the lamp ON and give the lamp more than 10 minutes to warm-up.
-
Perform a Wavelength Re-calibration after lamp warm-up.
NOTE
After lamp on, the detector requires a warm-up time of 60 min. No measurements should be performed during this time.
base-id: 3284768651
id: 9007202539509643