Injector Steps (G4767A SFC Multisampler)

Each movement of the sampling sequence can be done under manual control. This is useful during troubleshooting, where close observation of each of the sampling steps is required to confirm a specific failure mode or verify successful completion of a repair. Each injector step command actually consists of a series of individual commands that move the multisampler components to predefined positions, enabling the specific step to be done.

Run the Injector Steps in the Service & Diagnostics View in the Agilent Lab Advisor (for further information see Online-Help of user interface).
Select the individual step command like needle selection and needle position (for further information see Online-Help of user interface).

NOTE

Follow a logical order to use the injector steps function.