Software Update
If the Assist Hub is connected to the Internet and has an Assist Control Software Version of 2.0 or higher, then the software generates a notification when an update is available.
Optional: Download Software Updates Manually
You can manually check for software updates. Updates are available under:https://update.pl29.agilent.com/infinitylab. Check regularly for new updates.
You can use a USB storage media to store the update files. It must be of type exFAT, FAT32, EXT4. Both, the Assist Interface and the Assist Hub consist of a USB connector.
If you start InfinityLab Assist remotely in a Web browser, you can also store the update files to a known location on the PC and select software or firmware updates manually. A Chromium-based browser is required to open the Assist Control Software.
Check for Updates
Select
from the main toolbar.The Settings screen is displayed. A red dot on the General tab indicates that updates are available.
On the General tab, select Update.
The Update wizard is started. If Automatically Check for Updates is active and sources are accessible, the available software and firmware updates are listed.
Otherwise, select Check for Updates.
If update sources are accessible, the available software and firmware updates are listed.
If you started InfinityLab Assist remotely in a Web browser, you can also select Browse to search the file system yourself and select software or firmware updates manually.
Select Update
Select the desired update.
Select Continue With Selection.
If the Update wizard cannot open the file, you need to check for updates again. Otherwise, the content of the update file is displayed.
If a new firmware version is not compatible with the installed LC/CE Drivers version, the Update wizard displays the version number of the required LC/CE Drivers version. To skip the firmware update, clear the Firmware Update check box. Or install the required LC/CE Drivers version. Or cancel the Update wizard.
To filter out changes that do not apply to modules in your instrument, select the HW configuration relevant changes only check box
To display the release notes, select
.
Install Update (Automatic Restart)
Select the Automatic restart after update check box.
Select Install Update.
The Update wizard uploads the update file. A progress indicator shows the progress. When the upload is finished successfully, the Assist Hub restarts after 60 seconds. If the instrument is then busy, the restart will be executed when the instrument is idle again.
The buttons Restart Later and Restart Now are displayed. The Restart Now button is only active when the instrument is idle.
To postpone the restart, select Restart Later.
The Assist Hub will restart with the installed update after the Assist Hub has been turned off and on again.
To restart immediately, select Restart Now.
The Assist Hub restarts with the installed update.
Install Update (Manual Restart)
Clear the Automatic restart after update check box.
Select Install Update.
The Update wizard uploads the update file. A progress indicator shows the progress. When the upload is finished successfully and the instrument is idle, the Restart Now button is displayed. If the instrument is busy, the restart is postponed until the instrument is idle.
To restart immediately, select Restart Now.
The Assist Hub restarts with the installed update.
base-id: 13027880459
id: 13027880459