Agilent User Information System

Click here to see this page in full context

Home >
Operation >
Prepare Instrument for Run >
Preparation of the G7123B Fluorescence Detector >
Set Up the Detector with Agilent Open Lab

Set Up the Detector with Agilent Open Lab

The setup of the detector is shown with Agilent OpenLab 2.8 and Driver 3.11.

NOTE

This section describes the detector settings only. For information on Agilent OpenLab or other 1200 Infinity modules refer to the corresponding documentation.

Agilent OpenLab Method and Run Control (just detector is shown) — Figure: Agilent OpenLab Method and Run Control (just detector is shown)

After successful load of OpenLab, you should see the module as an active item in the graphical user interface (GUI).

base-id: 13910995723

id: 9007213165736715

18-Feb-2026

×